Can mast be left standing

[vouz etes ici]

Thanks for the responses... If I use a Dremel or grinder with a cut-off wheel, do I risk compromising the strength of the wire with the heat it would generate?

[Russ L]

A grinder to cut cable will change the metalurgy enough that you may have rust bleeding in/around the fitting unless you "pickle" the cut with an acid paste, available at welding supply. There is no time savings over a good old hacksaw with the best blade you can find (bimetal or hi-zoot). An improvement for the hacksaw (mentioned here earlier) is to drill a 2 X 4 (hole is wire size), slip the wire in the hole and cut it through the wood lengthwise, using the wood as a guide.

To leave a mast standing while fitting wire lengths it should be supported by four points, either uppers or lowers.. your choice. This can be accomplished utilizing strops & handy billys. In this way you can position the mast, plumb athwrtships & proper rake, in order to get the wire lengths correct.

It sounds like fun, I wish I was there to help
Cheers, Russ

[vouz etes ici]

I wish you could come!

Thanks for the suggestions. The yard will hoist it with the crane and will leave the crane in place as need be. The forestay is already done.

Its a fairly stout rig and the mast does not bend a whole lot (1974 Pearson 39). Perhaps I will do the backstay and the aft lowers first and try and position for the uppers and forward lowers.

Thanks for your advice!