Chainplate fabrication

		SparTalk > SparTalk
Chainplate fabrication

10-31-2014, 10:33 AM

Jim Fulton Jim Fulton is offline

Member

Join Date: Jun 2005

Posts: 69

I would begin with 1/2" holes. You can always relieve them a little if necessary. It's much harder to make them smaller.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is On

All times are GMT -7. The time now is 01:32 PM.