Cutout for line exit plate

		SparTalk > SparTalk
Cutout for line exit plate

Thread Tools

Display Modes

09-18-2011, 10:32 AM

memelet

Junior Member

Join Date: Jan 2007

Posts: 24

My understanding is that there should be no sharp corners in cuts in the spar. Only rounded. Is it enough that on the flat side of cutout there is a very small radius of rounding rather than like on the opposite side?

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is On

All times are GMT -7. The time now is 04:54 PM.